User Tools

Site Tools


elecraft_kx3_wintest_sdr_paddle_at_the_same_time

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

elecraft_kx3_wintest_sdr_paddle_at_the_same_time [2018/02/03 17:58] (current)
Line 1: Line 1:
 +How to connect KX3 to WinTEST ?
  
 +  * Set config RS232 to "​38400b",​ check with "KX3 uttility",​ that rig chat with PC through internal terminal, good idea to update software / firmware. Remember to backup settings.
 +  * Set config RX IQ to ON (for SDR)
 +  * Connect paddle to CWKEY1 and set it in config to tip:dot
 +  * Connect rig's control cable to ACC1, as usual.
 +  * Connect hand-made adapter to CWKEY2 and set it in config to hand (straight key)
 +  * (instructions to made: wintest "other inferface"​ with BC547 transistor, solder inside of DB9-F, connect to computer / through USB-Serial adapter, cost ~5 EUR + USB Adapter).
 +
 +Install drivers for USB adapters, check they exist in Device Manageer
 +
 +Write down COM ports' numbers
 +
 +my example:
 +
 +  *      com 7 : physical control cable for rig
 +  *      com 11: physical keying cable through USB adapter to CWKEY2
 +
 +Install LP-BRIDGE
 +  *   set K3 port to COM7 (look for you specification)
 +  *   set virtual port 1 to COM12 (look for you specification) (for wintest)
 +  *   set SDR port to COM19 (look for you specification) (for SDR)
 +
 +Install Win-TEST
 +  *   ​control > control interface
 +  *   com11 > other interface >> DTR4 CW, RTS OFF
 +  *   com12 > radio 1 >> 38400 8 N 1
 +  *   radio 1 > elecraft k3
 +
 +Install NaP3
 +
 +  * set port to COM19, 38400
 +
 +depends on your soundcard, check in "​recording devices",​ must be stereo.
elecraft_kx3_wintest_sdr_paddle_at_the_same_time.txt ยท Last modified: 2018/02/03 17:58 (external edit)